Back to PE30
PE30 Electrical Specifications
Installation/Setup
Warranty
Contact Us
Links
Home Page
Mechanical Specifications and Wiring
PE30 Dimensions PE30-NO Wiring Diagram
Housing w/mounting nuts:      33% glass-filled nylon 6/12, black

Encapsulation :      epoxy

Cable:     12" pigtail, #18 SAE type SXL, cross-linked polyethylene insulation

Cable Sheath:     Irradiated PVC

Attention OEMs:     We will quote PE30s with cables and connectors to your specifications on orders of 1,000 pcs. or more		 PE30-NC Wiring Diagram
Mechanical Specifications Wiring Diagrams


Electrical Specifications
Input Voltage Operating Current
nominal		 Leakage Current
maximum		   Output Current
maximum		 Output Drop
maximum
10-30 VDC 16 mA 50 uA   700 mA 1. 5 VDC
Standard Target
steel		 Sensitivity
over temp. range		 Supply Voltage
Sensitivity
maximum		 Hysteresis
maximum		 Repetition Accuracy
maximum / 100 X		 Switching Frequency
maximum
30mm 2 x 1mm
1. 18" 2 x . 04"		 10mm +/- 2mm
. 39" +/- . 08"		 +/- . 25mm
+/- . 01"		 5% of nominal
sensitivity		 . 03mm
. 001"		 20 Hz
Insulation
Resistance		 Voltage
Resistance
for 1 min.		 Short-Circuit
Protection
output to supply		 Reverse Supply
Voltage		 Irregular Supply
Voltage		 Load Dump
across supply terminals
50 Megohms
500 VDC		 500 VAC
50/60 HZ 		withstand direct short
15mS power-off reset		 600 VDC
for 30 min.		 500 VDC
for 10 uS		 withstand 130 VDC
for 100 mS
Shock
Resistance
5X each		 Vibration
Resistance
3 mins. each		 Temperature
Range		 Relative
Humidity		 Immersion
Resistance
H2O, 5 mins.		 Chemical
Effects
physical/electrical
degradation
25g, 11mS half sine pulses
x, y & z axes		 20g
x, y & z axes		 -40o C to +71o C
-40o F to +160o F		 0 - 95% fully functional
after air dry		 none
as a result of exposure to
lubricants, chemicals and
fuels normally used in the farm and automotive industries


Installation/Setup Procedures
Mechanical Installation Electrical Installation
     Use the nuts supplied with the switch to mount it to a bracket with M30 x 1.5 threads or a through-hole for 30mm.

     Multiple units must be spaced at least 20mm apart laterally, and the sensing face of each unit must extend a minimum of 20mm beyond any metal parts or mounting brackets.

      Your switch's electrical connections must agree with those shown in the corresponding wiring diagram above.
Setup Procedure
      These units have a factory-set sensitivity level - adjustment of the switching point is a function of switch positioning.
 


Top of Page phone:
+1 800. 315. 9233		 email:
sales@gordonproducts.com		 fax:
+1 203. 775. 1162		 Home Page
© copyright 2008 Gordon Products Incorporated