Installation/Setup Procedures
Mechanical Installation		Electrical Installation
The unit should be inserted and soldered into a printed circuit board.  The pins are .025" square and the pin spacing is on .100" centers.      The non-sensing faces of shielded units may touch each other, but non-shielded units must be a minimum of .063" apart.      We recommend keying the holes in the printed circuit board, to eliminate the possiblity of insertion error.		Your printed circuit board connections must agree with those shown in the wiring diagram above.
Setup Procedure
There is no setup required for PE16 Series switches. These units have a factory-set sensitivity level - once the printed circuit board design is finalized, it's simply a matter of inserting the PE16 as you would any other component.

	phone: +1 800. 315. 9233	email: sales@gordonproducts.com	fax: +1 203. 775. 1162
	© copyright 2008 Gordon Products Incorporated