Back to PC150
PC150 Electrical Specifications
Installation/Setup
Warranty
Contact Us
Links
Home Page
Mechanical Specifications and Wiring
PC150 Dimensions PC150-NO Wiring Diagram
Housing :    molded, ABS plastic
w/ a .062" ( 1.59 mm ) stainless steel backplate

Encapsulation :      none

Power/Output Cable:     2 meters ( 4 wires ), standard

Adjustment:     15-turn potentiometer

Output Indicator:     LED, lit when output is conducting		 PC150-NC Wiring Diagram
Mechanical Specifications Wiring Diagrams


Electrical Specifications
Input Voltage Supply Ripple Operating Current
nominal		   Leakage Current
maximum		 Output Current
maximum
10-30 VDC 10% 12 mA   2 uA 100 mA
Sensitivity
maximum
w/ 6" x 6" grounded
metal target		 Temperature
Range		 Relative
Humidity		 General
Environment
3"
76. 2 mm		 +50o F to +130o F
+10o C to +55o C		 0 - 95% unaffected by normal factory conditions
of dirt, grease and vibration


Installation/Setup Procedures
Mechanical Installation Electrical Installation
Use the sensor's four mounting holes, which are .196" ( 4.98 mm ) in diameter, to fasten the sensor securely.
The unit may be mounted directly to a grounded metal bulkhead or bracket.

Multiple units must be spaced at least 150 mm apart, laterally.

 Your switch's electrical connections must agree with those shown in the corresponding wiring diagram above.
Setup Procedure
Apply power.

With no target present, turn the adjustment potentiometer CW until an alarm condition exists
( Normally Open - LED is lit;  Normally Closed - LED is off ).

Then, turn the pot CCW until the alarm just resets. This is the point of maximum possible sensitivity;
this is not the recommended operating point, however, as temperature fluctuations may cause false alarms or detection failures.

For the optimum setting, put a target at the desired detection point and ensure that the switch is alarmed. Turn the pot CCW until the unit just resets, noting the number of turns to reset. Return CW half this number of turns.

Note:   A minimum of  ¼  turn CW is recommended to ensure stable operation.
 


Top of Page phone:
+1 800. 315. 9233		 email:
sales@gordonproducts.com		 fax:
+1 203. 775. 1162		 Home Page
© copyright 2008 Gordon Products Incorporated